1, The control circuit and the LED share the only power source.

2, The control circuit and RGB chip are integrated in a 5050 components, to form an external control pixel.

3, Using the built-in signal reshaping circuit to achieve the signal waveform shaping, and no distortion of waveform of signal takes place.

4,  Built-in power-on reset and brown-out reset circuits.

5, The gray levels of each pixel are of 256 levels, which achieves “256*256*256=16777216” full-color display, and the refresh frequency reaches to 2KHz/s.

6, Serial cascade interface, data receiving and decoding depend on just one signal line.

7, Dual-signal wires version, signal break-point continuous transmission.

8, Any two point the distance more than 3m transmission signal without any increase circuit.

9, When the refresh rate is 30fps, cascade numbers are far more than 1024 points.

10, Data transmitting at speeds of up to 800Kbps.

11, Good color consistency reliability, high cost-effective

12,The BIN receives the data signal, and then compare the data with the DIN side after phagocytosis of 24bit data, if DIN do NOT receive the signal, then switching to BIN for receiving the input signal, which ensure that any the IC’s damage does not affect the signal cascade transmission and make the BIN in state of receiving signal until restart after power-off.

13,Low Frame Frequency and no Flicker appear in HD Video Camera.  250us or more of reset time, it won’t cause wrong reset while interruption, it supports the lower frequency and inexpensive MCU.